Page 1 of 1
Recording always fails to start - "ProgramNotFound"
Posted: Sat Jul 11, 2015 7:48 pm
by liamnewman
Hi,
I have been configuring my ARGUS setup for the last few days, and recording has typically worked. However, today I have reset my configuration and reset it for a proper implementation of Digiguide via XMLTV. I am able to watch channels, but recording them results in "ProgramNotFound" showing up almost always (I was able to record once). I am not sure why I receive this issue so often (I initially had the issue with watching television), so I'm hoping someone can help.
I have searched the forum, but none of the solutions matched the problem I had.
I have also attached my logs.
Thanks,
Liam
Re: Recording always fails to start - "ProgramNotFound"
Posted: Sun Jul 12, 2015 11:09 am
by liamnewman
I have looked further into the problem. The issue occurs on the first card. My system is a dual-tuner system that also uses encrypted channels. The problems occur with the first tuner on encrypted channels; if it is not encrypted or if the second tuner records it, it goes through and records fine.
Re: Recording always fails to start - "ProgramNotFound"
Posted: Sun Jul 12, 2015 2:08 pm
by Christoph21x
Hey Liam
Which card system do you use for decryption?
Recommended first action (no solution, just as an interim-amelioration): flip your card priority in the Recorder Console / Cards (or alternatively in the TVServer of MediaPortal addressing new card priority & rearranging them)
Greetz - Chris
liamnewman wrote:I have looked further into the problem. The issue occurs on the first card. My system is a dual-tuner system that also uses encrypted channels. The problems occur with the first tuner on encrypted channels; if it is not encrypted or if the second tuner records it, it goes through and records fine.
Re: Recording always fails to start - "ProgramNotFound"
Posted: Sun Jul 12, 2015 3:12 pm
by liamnewman
Hi Christoph21x,
1. I am using ACamd.
2. I have swapped the card priorities, but now card 2 is having the error, and Card 1 decrypts and records fine.
I should probably state that the tuner is on the latest drivers, so outdated drivers are not an issue. The card itself is a BlackGold 3600 Quad Tuner (2 DVB-S, 2 DVB-T), which worked fine in DVBLink, and also worked fine in Argus until recently.
Thanks,
Liam
Re: Recording always fails to start - "ProgramNotFound"
Posted: Sun Jul 12, 2015 6:35 pm
by Christoph21x
Hey Liam, did you try to use the search engine of this forum?
I remembered, there was (more than once) a reported issue with ACamd, which was solvable - maybe you would want to search first?
Found one, that might suit your issue:
viewtopic.php?f=49&t=5730&hilit=ACamd
Let me know, pls.
Greetz - Chris